Incra Miter 1000HD Uživatelský manuál stáhnout pdf (Strana 8)

Page 8

Manufactured by Taylor Design Group, Inc. P.O. BOX 810262 Dallas, TX 75381 W W W . I N C R A . C O M

MADE IN THE

USA

Manufactured by:

Taylor Design Group, Inc.

P.O. BOX 810262 Dallas, TX 75381

www.incra.com

INCRA Tools are protected by one or more of the following US patents:

#4,793,604, #4,930,221, #5,195,730, #5,275,074, #5,423,360, #5,716,045, #6,237,457,

#6,557,601, #6,672,190. Other patents granted or pending.

INCRA is a Registered Trademark of Taylor Design Group, Inc.

INCRA MIteR1000HD OWNER’S MANUAL

0° 1/10° left of 0° 2/10° left of 0° 3/10° left of 0°

5/10° left of 0° 6/10° left of 0° 7/10° left of 0°4/10° left of 0°

9/10° left of 0°8/10° left of 0°

Using Your New

1/10

° Vernier Cursor

Your new Miter1000HD features several enhancements not included with the

standard Miter1000. Among these is the new 1/10° vernier cursor.

For readings in 1° increments using the cursor, just align any of the protractor scale

marks with the “0” mark on the cursor. For 1/10° adjustments, you will notice 5 marks

on either side of the “0” mark on the cursor. As you gently rotate the protractor you

will read the scale as follows: At 1/10° rotation, the rst mark aligns 1° away from the

original starting point. At 2/10° rotation, the second mark aligns 2° away. At 3/10°

rotation, the third mark aligns 3° away, etc. For 6/10° through 9/10° of rotation, watch

for alignments using the marks on the opposite side of the “0” cursor mark.

Sound complicated? It’s not! Just study the examples on this page.

1 2 3 4 5 6 7 8

Žádné komentáře

Incra Miter 1000HD Uživatelský manuál Strana 8